9mm Ballistics Chart 16 Inch Barrel

Owners of 16 inch 9mm carbines usually have to guess what their ammunition is doing, because handgun barrels are what the factories use for testing. This page replaces the guesswork with published numbers: ten loads clocked out of 16 inch barrels to begin with, then the single factory load sold with a full 16 inch downrange chart, and finally the one remaining factory load rated in a barrel of this length.

All velocities below are feet per second. Energy is shown in foot-pounds, trajectory in inches and range in yards.

Muzzle Velocity at 16 Inches: Ten Loads

Load16 in Test Barrel (fps)Kel Tec Sub-2000, 16 in (fps)Beretta Cx4 Storm, 16 in (fps)
Cor Bon 90 gr JHP +P174017511751
Cor Bon 115 gr JHP +P152515241489
Cor Bon 125 gr JHP +P143013871354
Cor Bon 115 gr DPX147613851345
Federal 115 gr JHP129513171287
Federal 105 gr Expanding FMJ135813481316
Federal 124 gr Hydra-Shok JHP124312701252
Federal 135 gr Hydra-Shok JHP Low Recoil118512271188
Federal 147 gr Hydra-Shok JHP107310861049
Speer 124 gr Gold Dot Short Barrel137913911354

In the graphic, the loads are ranked by test barrel speed and each one carries a bar for the test barrel plus a bar for each of the two carbines.

See also  243 vs 223 ballistics chart

Light Bullets Own the Top Rows

The lightest bullet on the page, Cor Bon’s 90 grain +P hollow point, also posts the highest speed at 1,740 fps in the test barrel. Cor Bon holds the next three places too, its 115 grain loads and 125 grain load landing between 1,430 and 1,525 fps. Speer’s 124 grain Gold Dot Short Barrel, a load meant for short pistol barrels, still managed 1,379 fps when given 16 inches to work with.

Where the Heavy Loads Land

At the other end, Federal’s 147 grain Hydra-Shok records the lowest reading of the set, 1,073 fps in the test barrel and 1,049 fps from the Cx4 Storm. The 135 grain low recoil Hydra-Shok sits one step above it at 1,185 fps. Even so, every load in the table clears 1,000 fps with room to spare out of a carbine length tube.

Reading the Two Carbine Columns

Comparing the production guns against the test barrel shows how little the individual firearm matters at this length. The Sub-2000 never trailed the Cx4 Storm across the ten loads, and its largest advantage was the 40 fps it held over the Beretta with Cor Bon’s 115 grain DPX. Several loads actually ran faster in the Kel Tec than in the test barrel, among them Federal’s 115 grain JHP at 1,317 fps against 1,295 fps.

The Factory 16 Inch Chart in Full

BrandLoadProduct LineSKUTest Barrel (in)Velocity 0 yd (fps)Velocity 25 yd (fps)Velocity 50 yd (fps)Velocity 75 yd (fps)Velocity 100 yd (fps)Energy 0 yd (ft-lb)Energy 25 yd (ft-lb)Energy 50 yd (ft-lb)Energy 75 yd (ft-lb)Energy 100 yd (ft-lb)Trajectory 25 yd (in)Trajectory 50 yd (in)Trajectory 75 yd (in)Trajectory 100 yd (in)
Federal130 gr Syntech Jacket Flat NoseSyntechAE9SJPC11611401086104210049723753413132912730-0.9-3.9-8.9

The trajectory line is built on a 25 yard zero and a sight line 0.9 inches over the bore. Federal does not give a ballistic coefficient for this load.

See also  22 ARC vs 22 Creedmoor Ballistics Chart

Syntech PCC, Yard by Yard

Velocity bleeds away gradually for the Federal load: 1,086 fps at 25 yards, 1,004 fps at 75 yards and 972 fps when the bullet reaches 100 yards. Energy tracks that decline from 375 ft-lb down to 273 ft-lb. The drop figures stay modest inside normal carbine distances, with the bullet only 0.9 inches under the sight line at 50 yards before falling to 8.9 inches low at 100 yards.

The Second Factory Load, Muzzle Figures Only

BrandLoadSKUMuzzle Velocity (fps)Muzzle Energy (ft-lb)
Lehigh Defense118 gr Maximum Expansion +PLA9C-118-ME-P1240403

Lehigh Defense built this 118 grain +P load specifically for carbines and measured it in a 16 inch barrel, but the company releases nothing beyond muzzle numbers. Those numbers are strong ones: 1,240 fps makes it the quickest factory load on the page, and 403 ft-lb gives it the highest muzzle energy found here.

A Short Factory List, by Design

Nothing else joins these two in the factory tables, and the reason is simple. The remaining 9mm loads on record were all measured in barrels of 8 inches or shorter, since the cartridge is developed around handguns. Rather than present a pistol length figure as though it were carbine data, this article limits its factory tables to loads with a genuine 16 inch test barrel behind them.

FAQs

Which factory loads actually carry a 16 inch test barrel?
Just two of them: a 130 grain Syntech load from Federal and a 118 grain Maximum Expansion +P load from Lehigh Defense.

See also  257 Roberts Ballistics - Trajectory and Bullet Drop Chart

What is the highest velocity anywhere in the ten load table?
Both production carbines pushed Cor Bon’s 90 grain JHP +P to 1,751 fps, a touch above the 1,740 fps the same load recorded in the test barrel.

How does the Federal carbine load perform at the muzzle?
Its published starting point is 1,140 fps and 375 ft-lb, taken from the 16 inch test barrel named on the product page.

What remains of the Federal load at 100 yards?
By 100 yards it holds 972 fps and 273 ft-lb, and it prints 8.9 inches beneath the sight line on its 25 yard zero.

How was the Federal trajectory zeroed?
Federal zeroed it at 25 yards with the sights sitting 0.9 inches above the bore line, so the 25 yard trajectory cell reads exactly zero.

Does Lehigh Defense publish downrange data for its carbine load?
It does not. The 118 grain load is documented only at the muzzle, where it is rated at 1,240 fps and 403 ft-lb.

How close are the Sub-2000 and Cx4 Storm to each other?
Very close. The Kel Tec equalled or outran the Beretta with all ten loads, and the widest separation between the two guns was only 40 fps.

Which load brings up the rear of the velocity table?
Federal’s 147 grain Hydra-Shok JHP is the slowest of the ten, opening at 1,073 fps in the test barrel.

Do the factory tables include a ballistic coefficient column?
They do not, because neither maker publishes a BC value for its 16 inch load and no column is carried without data behind it.

Can pistol barrel figures stand in for 16 inch figures?
They cannot. A load tested in a short handgun barrel posts different numbers, so this page keeps such loads out of the factory tables entirely.

Leave a Comment